Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
TRIGger:A:BU
S:B<x>:ETHERnet:QUALifier
This command specifies the qualifier to be used when the Ethernet trigger
condition is set to
MACLENgth or DATa . Normally, the Ethernet qualifier is set to
“Equal to”.
B
<x>
is the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:ETHERnet:QUALifier
{LESSthan|MOREthan|EQual|UNEQual|LESSE Qual|MOREEQual
|INrange|OUTrange}
TRIGger:A:BUS:B<x>:ETHERnet:QUALifier?
Related Commands
TRIGger:A:BUS:B<x>:ETHERnet:CONDition
TRIGger:A:BUS:B<x>:ETHERnet:MAC{:LENgth|:TYPe}:VALue
TRIGger:A:BUS:B<x>:ETHERnet:MAC{:LENgth|:TYPe}:HIVALue
TRIGger:A:BUS:B<x>:ETHERnet:DATa:VALue
TRIGger:A:BUS:B<x>:ETHERnet:DATa:HIVALue
Examples
TRIGger:A:BUS:B1:ETHERnet:QUALifier LESSthan sets the MACLENgth
or DATa
qualifier to less than.
TRIGger:A:BUS:B<x>:ETHERnet:TCPHeader:ACKnum:VALue
When the Ethernet trigger condition is set to TCPHeader, this command specifies
the 32–bit acknowledgement number that is to be used in the trigger (along with
the destination and source port addresses and the sequence number). The default
is all X’s (don’t care).
B<x> is the bus number B1-B4.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Trigger
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-805

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English