Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
TRIGger:A:BUS
:B<x>:MIL1553B:COMMAND:ADDRess:VALue to specify
the lower limit of the range.) The default is all X’s (don’t care).
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:AD DRess:HIVALue
<QString>
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:AD DRess:HIVALue?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:ADDRess:QUALifier
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:ADDRess:VALue
Arguments
QString is a quoted string of up to 5 characters where the allowable characters
are 0, 1, and X. The bits specified in the quoted string replace the leas
tsignificant
bits, leaving any unspecified upper bits unchanged.
Examples
TRIGger:A:BUS:B1:MIL1553B:HIVALue “01000” sets the upper limit of the
remote terminal address range to 01000 (when the trigger condition has been set
to
MIL1553B, and the qualifier has been set to INrange or OUTrange).
TRIGger:A:BUS:B1:MIL1553B:HIVALue?
might return “XXXXX”.
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:ADDRess:QUALifier
When the MIL-STD-1553 bus trigger condition is set to COMMAND, this command
specifies the qualifier to
be used with the remote terminal address field.
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-831

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English