Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:USB:ADDRess:HIVALue <QString>
TRIGger:A:BUS:B<x>:USB:ADDRess:HIVALue ?
Related Commands
TRIGger:A:BUS:B<x>:USB:CONDition,
TRIGger:A:BUS:B<x>:USB:ADDRess:VALue
Arguments
<QString> within the range 0000000 to 1111111 (00 hex to 7F hex).
Examples
TRIGGER:A:BUS:B1:USB:ADDRESS:HIVALUE “0001000” sets the upper limit
to binary 0001000 (08 hex).
TRIGGER:A:BUS:B1:USB:ADDRESS:HIVALUE? might return
:TRIGGER:A:BUS:B1:USB:ADDRESS:HIVALUE “1111111”, which indicates
that the upper limit is 1111111 (7F hex).
TRIGger:A:BUS:B<x>:USB:ADDRess:VALue
This command specifies the binary address string to be used for USB trigger.
This command also specifies the binary address string for the lower limit for
inside-of-range and outside-of-range qualifiers for the USB trigger.
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:USB:ADDRess:VALue <Qstring>
TRIGger:A:BUS:B<x>:USB:ADDRess:VALue?
Related Commands
TRIGger:A:BUS:B<x>:USB:CONDition
Arguments
<QString> within the range 0000000 to 1111111 (00 hex to 7F hex).
Examples
TRIGGER:A:BUS:B1:USB:ADDRESS:VALUE “0001000” sets the binary
address to 0001000 (08 hex).
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-859
To Next Page
Loading...
Need help?
General
