Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:SPI:DATa{:OUT|:MOSI }:VALue <QString>
TRIGger:A:BUS:B<x>:SPI:DATa{:OUT|:MOSI }:VALue?
Arguments
<QString> is the binary data string with the number of bits specified by the
TRIGger:A:BUS:B<x>:SPI:DATa:SIZe command. The only allowed characters
in the
QString are0,1,andX.
TRIGger:A:BUS:B<x>:SPI:DATa:SIZe
This command specifies the length of the data string to be used for a SPI trigger if
the trigger condition is MISO, MOSI, or MISOMOSI.
B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:SPI:DATa:SIZe <NR1>
TRIGger:A:BUS:B<x>:SPI:DATa:SIZe?
Arguments
<NR1> is the length of the data string in bytes.
TRIGger:A:BUS:B<x>:USB:ADDRess:HIVALue
This command specifies the binary address string for the upper limit for
inside-of-range and outside-of-range qualifiers for the USB trigger. Use the
command TRIGger:A:BUS:B<x>:USB:ADDRess:VALue to set the lower limit.
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
2-858 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English