Performance Verification
The performance verification procedures verify the performance of your
instrument. They do not adjust your instrument. If your instrument fails any
of the perfor
mance verification tests, you should contact Tektronix to have the
factory adjustment performed. See the contact information on the back of the
title page of this manual.
This section contains performance verification procedures for the specifications
marked with the
symbol. These procedures cover all MDO4000 Series models.
Please ignore checks that do not apply to the specific model you are testing.
Print the test record on the following pages and use it to record the performa nce
test results for your oscilloscope.
NOTE. Completion of the performance verification procedure does not update the
stored time and date of the latest successful adjustment. The date and time are
update
d only when the instrument is adjusted by Tektronix.
MDO4000 Series Specifications and Performance Verification 27
To Next Page
Loading...
Need help?
General
