Adjustments
There are no customer-performable adjustment procedures (calibrations) for
the TBS2000 Series oscilloscopes. Please return the instrument to Tektronix
if adjustment is required. Calibrations can only be performed at a Tektronix
service center and require the use of traceable test equipment (signal sources and
measuring e
quipment) to verify the performance of the instrument.
To determine if adjustment is required, use the Performance Verification
procedure
in the TBS2000 Series Digital Storage Oscilloscopes Specifications and
Performance Verification manual (tektronix part number 077-1148-xx), available
at www.tek.com/downloads. Adjustment is also required after instrument repair.
TBS2000 Series Service Manual 3–1
To Next Page
Loading...
