Replaceable parts list
This chapter contains a list of the replaceable modules for these oscilloscopes.
Use this list to identify a nd order replacement parts.
Parts ordering information
Replacement parts are available through your local Tektronix field offi ce or
representative.
Changes to Tektronix products are sometimes made to accommodate improved
components as they become available and to give you the benefit of the latest
improvements. Therefore, when ordering parts, it is important to include the
following information in your order:
Part number (see Part Number Revision Level below)
Instrument type or model number
Instrument serial number
Instrument modification number, if applicable
If you order a part that is replaced with a different or improved part, your local
Tektronix field office or representative will contact you concerning any change in
part number.
Change information, if any, is located at the rear of this manual.
Part number revision level
Tektronix part numbers contain two digits that show the revision level of the
part. For some parts in this manual, you will find the letters “xx” in place of the
revision level number.
When you order parts, Tektronix will provide you with the most current part for
your product type, serial number, and modification (if applicable). At the time of
your o rder, Tektronix will determine the part number revision level needed for
your product, based on the information you provide.
Module servicing
Modules can be serviced by selecting one of the next three options. Contact your
local Tektronix service center or representative for repair assistance.
Module exchange. In some cases you may exchange your module for a
remanufactured module. These modules cost significantly less than new modules
TBS2000 Series Service Manual 5–1
To Next Page
Loading...
Need help?
General
