Maintenance
Unpacking and repacking instructions
This section contains the information needed to unpack the oscilloscope and
repack it for shipment or storage.
Unpacking
The oscilloscope and its standard accessories are carefully packed at the factory in
a shipping carton. If, upon receipt, damage to the shipping carton is evident, tell
the shipper. Tektronix, Inc. is not responsible for damage caused during shipping.
If you have not already done so, carefully remove the oscilloscope and its
accessories from the shipping carton and inspect them for damage. Save the
shipping carton for repacking or storage.
Repacking
Use a corrugated c ardboard shipping carton having a test strength of at least 2 75
pounds (125 kg) and with an inside dimension at least six inches (15.25 cm)
greater than the instrument dimensions.
If the instrument is being shipped to a Tektronix Service Center, enclose the
following information:
The owner’s address
Name and phone number of a contact person
Type and serial number of the instrument
Reas
on for returning
A complete description of the service required
Seal the shipping carton with an industrial stapler or strapping tape.
Mark the address of the Tektronix Service Center and also your own return address
on the shipping carton in two prominent locations. See www.tektronix.com/service
to find a service center near you.
S
torage
The oscilloscope should be stored in a clean, dry environment. The following
environmental characteristics apply for both shipping and storage:
Temperaturerange:-4°Fto+140°F(-20°Cto+60°C)
Altitude: To 39,370 feet (12,000 m )
See the Tektronix TBS2000 Series Digital Storage Oscilloscopes Specifications
and Performance Verification Technical Reference (Tektronix part number
077-1148-xx) for a complete listing of the environmental s pecifications.
4–10 TBS2000 Series Service Manual
To Next Page
Loading...
Need help?
General
