EasyManua.ls Logo

Tektronix TDS1002

Tektronix TDS1002
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−47
CALibrate:INTERNAL
CALibrate:ABOrt (No Query Form)
NOTE. You should only use this command in a qualified service
environment. For more information about the factory calibration
sequence, refer to the sevice manual for your oscilloscope.
Aborts the factory calibration process. When you abort the factory
calibration, the oscilloscope restores the calibration settings to the
previous factory calibration constants stored in non-volatile memory.
Calibration and Diagnostic
CALibrate:ABOrt
CALibrate:ABOrt
stops the in-process factory calibration procedure.
CALibrate:CONTINUE (No Query Form)
NOTE. You should only use this command in a qualified service
environment. For more information about the factory calibration
sequence, refer to the sevice manual for your oscilloscope.
Performs the next step in the factory calibration operation.
Calibration and Diagnostic
Related Commands
Group
Syntax
Examples
Group

Table of Contents

Other manuals for Tektronix TDS1002

Related product manuals