EasyManuals Logo

Tektronix TDS1002 Programmer's Manual

Tektronix TDS1002
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
Command Descriptions
2−66
TDS200/1000/2000 Series Oscilloscope Programmer Manual
Refer to Waveform Commands on page 2-27 for a description of the
waveform transfer process.
Waveform
CURVe { <Block> | <asc curve> }
CURVe?
<Block> is the waveform data in binary format. The waveform is
formatted as: #<x><yyy><data> where <x> is the number of
characters in <yyy>. For example, if <yyy> = 500, then <x> = 3,
where <yyy> is the number of bytes to transfer. Refer to Block
Arguments on page 2-12 for more information.
If width is 1, then all bytes on the bus are single data points. If width
is 2, then all bytes on the bus are 2-byte pairs. Use the DATa:WIDth
command to set the width. <data> is the curve data.
<asc curve> is the waveform data in ASCII format. The format for
ASCII data is <NR1>[,<NR1>...] where each <NR1> represents a
data point.
SELect:CH1 ON
DATa:ENCdg ASCIi
DATa:SOUrce CH1
CURVe?
might return the ASCII data
:CURVE13,6,3,2,–1,–9,–14,–19,–29,–35,–67,–1,–78,–62,
–50,–31,–27,–7,0,12,29,39,45,43,41,47,41,38,33,26
DATa, WFMPre
Group
Syntax
Arguments
Examples
Related Commands

Table of Contents

Other manuals for Tektronix TDS1002

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS1002 and is the answer not in the manual?

Tektronix TDS1002 Specifications

General IconGeneral
Bandwidth60 MHz
Channels2
Sample Rate1 GS/s
Record Length2.5k points
Vertical Sensitivity2 mV/div to 5 V/div
Vertical Resolution8 bits
Display Resolution320 x 240 pixels
Display5.7 inch monochrome LCD
Trigger ModesVideo, Edge
ConnectivityUSB 2.0
Weight2.0 kg
Input Impedance1 MΩ
Power Supply100 to 240 VAC, 45 to 440 Hz

Related product manuals