Tektronix TDS1002 Programmer's Manual

Command Descriptions
2−68
TDS200/1000/2000 Series Oscilloscope Programmer Manual
DATa:DESTination
Sets or queries the reference memory location for storing oscillo-
scope waveform data that is transferred into the oscilloscope by the
CURVe command. This command is identical to the DATa:TARget
command.
Waveform
DATa:DESTination REF<x>
DATa:DESTination?
REF<x> is the reference memory location where the waveform will
be stored.
DATa:DESTINATION REFA
stores incoming waveform data into reference memory REFA.
DATa:DESTINATION?
might return REFB as the waveform location that is currently
selected.
CURVe?
DATa:ENCdg
Sets or queries the format of the waveform data. This command is
equivalent to setting WFMPre:ENCdg, WFMPre:BN_Fmt, and
WFMPre:BYT_Or as shown in Table 2-24 on page 2-70.
Setting the DATa:ENCdg value causes the corresponding WFMPre
values to update. Setting the WFMPre value causes the correspond-
ing DATa:ENCdg values to update.
Group
Syntax
Arguments
Examples
Related Commands

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz