Cursor
3-20
TDS3000B Serie s User Manual
Cursors at Same Position. If both cursors a re a t t he sam e posit ion, and
H Bars or V Bars are set to Ratio or Phase, both cursors are set to 0%
(or 0°). 100%/360° is set to one pixel width away from the cursor
position.
V Bars and FFT. When the selected waveform is an FFT waveform,
selecting V Bars and Phase sets the measurement to percent.
Tracking Mode. In cursor tracking mode, both cursors move together
when cursor 1 is selected. Enabling tracking mode automatically
selects cursor 1 as the active cursor. If cursor 2 is selected while in
tracking mode, only cursor 2 will m ove.
To Next Page
Loading...
Need help?
General
