TEL AFA4000/E - Over Current Monitor

AFA4000/E VAV Airflow Controller / p.105
7.4 Over Current Monitor
1. From the Run Screen press and hold the Mute button for 5 seconds until the Main Menu is
displayed.
2. Use the ↑ / ↓ buttons to select Set Up Auto Sash. The display shows the message TEL SASH
CLOSER.
3. Press the Mute button to display the current Hardware and Software version, for example, 1.
HW2.0 FW1.1.
4. Press the ↓ button to scroll down and select Setup Menu and press Mute.
5. Enter the password (the factory default password is 1-0-0-1) and press Mute.
6. In the Configuration menu the controller will display the message System Profile.
7. Use the ↓ button to scroll through the menu and select Sash Settings, then press Mute.
8. In the Configuration menu the display will show 1. Enabled.
9. Use the ↓ button to scroll through the menu and select 3. Motor Drive. Press Mute.
10. Use the ↓ button to scroll through the menu and select Motor Current Display, Press Mute.
11. Use the ↑ / ↓ buttons to select Max, Press Mute.
Note: Select Max to show the Peak current or Live to show the live value.
12. Use the ↓ button and select Back then Back to Set up menu. Press Mute.
13. Use the ↓ button and select Exit and Save Changes. Press Mute.
14. When the Motor drives, the selected Max or Live current will be displayed in the status bar.
15. Determine the current limit required for either sash open, sash close or both.
16. From the Run Screen press and hold the Mute button for 5 seconds until the Main Menu is
displayed.
17. Use the ↑ / ↓ buttons to select Set Up Auto Sash. The display shows the message TEL SASH
CLOSER.
18. Press the ↓ button to scroll down and select Setup Menu and press Mute.
19. Enter the password (the factory default password is 1-0-0-1) and press Mute.
20. Use the ↓ button to scroll through the menu and select Sash Settings, then press Mute.
21. Use the ↓ button to scroll through the menu and select 3. Motor Drive. Press Mute.
22. Use the ↓ button to scroll through the menu and select Motor Current Display, Press Mute.
23. Use the ↑ / ↓ buttons to select Off, Press Mute.
24. Use the ↓ button to scroll through the menu and select Over current Open, Press Mute.
25. Use the ↑ / ↓ buttons to set the required limit, Press Mute.
26. Use the ↓ button to scroll through the menu and select Over current Close, Press Mute.
27. Use the ↑ / ↓ buttons to set the required limit, Press Mute