• ISDN-BRI
(see Variable switching of S0 interfaces on page 37)
Connect the ISDN BRI interface (BRI1, BRI2 or BRI3, BRI4) of the device to your ISDN
socket using the ISDN BRI cable provided.
• ISDN-PRI (only bintec R4402)
Connect the ISDN PRI interface (PRI-1 or PRI-2) of the device to your PRI connection
using the ISDN PRI cable provided.
• Other LANs
Connect any other terminals in your network to the remaining switch ports ETH2, ETH3,
ETH4 or ETH5) of your device using other Ethernet cables.
• Serial connection
For alternative configuration possibilities, connect the serial interface of your PC (COM1
or COM2) to the serial interface of the gateway (console). However, configuration via the
serial interface is not provided by default.
• Analog telephone /analog fax (only bintec RT4202)
Connect your analog telephone or your analog fax to the FXS connections.
The device is now ready for configuration with the GUI. Chapter Basic configuration on
page 41 provides a detailed step-by-step guide to the basic functions on your device.
3.2 Cleaning
You can clean your device easily. Use a damp cloth or antistatic cloth. Do not use solvents.
Never use a dry cloth; the electrostatic charge could cause electronic faults. Make sure that
no moisture can enter the device and cause damage.
3 Installation Teldat GmbH
8 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
