Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• *" (default value): You enter a static IP address.
•   -##: Your device dynamically assigns an
IP address to the remote terminal.
•   -##: Your device is dynamically assigned an
IP address.
Default Route Only for IP Address Mode = *" and   -##
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with ,.
The function is disabled by default.
Create NAT Policy Only for IP Address Mode = *" and   -##
When you configure an ISDN Internet connection, specify
whether Network Address Translation (NAT) is to be activated.
The function is enabled with ,.
The function is disabled by default.
Local IP Address Only if IP Address Mode = *"
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = *"
Define other routing entries for this connection partner.
• @  -##: IP address of the destination host or
network.
• '#7: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• %": The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
17 WAN Teldat GmbH
290 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
