Field Description
• -52?-: Primarily run CHAP, otherwise PAP.
• %*2?-: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• -52?-5%*2?-: Primarily run CHAP, on denial then the
authentication protocol required by the connection partner.
(MSCHAP version 1 or 2 possible.)
• %*2?-: Run MS-CHAP version 2 only.
• ': Some providers use no authentication. In this case, se-
lect this option.
Encryption Only for Authentication = %*2?-
If necessary, select the type of encryption that should be used
for data traffic to the connection partner. This is only possible if
STAC or MS-STAC compression is not activated for the con-
nection. If Encryption is set, the remote terminal must also sup-
port it, otherwise a connection cannot be set up.
Possible values:
• ' (default value): MPP encryption is not used.
• ,: MPP encryption V2 with 128 bit is used to RFC
3078.
• 81# "),: MPP encryption V2 with 128 bit is
used as compatible with Microsoft and Cisco.
Callback Mode Select the Callback Mode function.
Possible values:
• ' (default value): Your device does not call back.
• -": Select one of the following options:
• ' : Your device calls the connection
partner to request a callback.
• 81# 2, %: Your device calls the connection
partner to request a callback via CBCP (Callback Control
Protocol). Needed for Windows clients.
• ##: Select one of the following options:
• ' 2/.: Your device calls back im-
mediately when requested to do so by the connection part-
ner.
17 WAN Teldat GmbH
292 bintec Rxxx2/RTxxx2
To Next Page
Need help?
General
