Field Description
• ## (default value): OSPF is not activated for this inter-
face, i.e. no OSPF protocol packets sent over this interface.
Networks reachable over this interface are, however, included
when calculating the routing information and propagated over
active interfaces.
• -": OSPF is not activated for this interface, i.e. OSPF
protocol packets sent over this interface.
• ": OSPF is disabled for this interface.
Proxy ARP Mode
Select whether and how ARP requests are to be responded to
for the specified connection partner.
Possible values:
• " (default value): Deactivates Proxy ARP for this
connection partner.
• 0)  .: Your device only responds to an ARP re-
quest if the status of the connection to the connection partner
is 0) or .. In the case of ,, your device only re-
sponds to the ARP request; the connection is not set up until
someone actually wants to use the route.
• 0) ,&: Your device responds to an ARP request only if the
status of the connection to the connection partner is 0) , i.e. a
connection already exists to the connection partner.
Choose the button to edit the configuration of the corresponding leased line for a PRI
interface.
Teldat GmbH
17 WAN
bintec Rxxx2/RTxxx2 319
To Next Page
Loading...
Need help?
General
