Field Description
The function is enabled by default.
Block Time Define how long a peer is blocked for tunnel setups after a
phase 1 tunnel setup has failed. This only affects locally initiated
setup attempts.
Possible values are to (seconds); means the
value in the default profile is used and means that the peer is
never blocked.
The default value is $.
NAT Traversal NAT Traversal (NAT-T) also enables IPSec tunnels to be
opened via one or more devices on which network address
translation (NAT) is activated.
Without NAT-T, incompatibilities may arise between IPSec and
NAT (see RFC 3715, section 2). These primarily prevent the
setup of an IPSec tunnel from a host within a LANs and behind
a NAT device to another host or device. NAT-T enables these
kinds of tunnels without conflicts with NAT device, activated
NAT is automatically detected by the IPSec Daemon and NAT-T
is used.
Only for > )!,#
Possible values:
• , (default value): NAT Traversal is enabled.
• .#,: NAT Traversal is disabled.
• 9": The device always behaves as it would if NAT were in
use.
Only for > )!,#
The function is enabled with ,.
The function is enabled by default.
CA Certificates Only for Phase-1 (IKE) Parameters
Only for Authentication Method = .*- * 3, @*-
* 3 or @*- "&)
If you enable the Trust the following CA certificates option,
18 VPN Teldat GmbH
348 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
