EasyManua.ls Logo

Teldat bintec RT1202 - Page 365

Teldat bintec RT1202
622 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Field Description
-* , a key length of 128 bits is used.
-*: Rijndael has been nominated as AES due to its
fast key setup, low memory requirements, high level of secur-
ity against attacks and general speed. Here, it is used with a
key length of 128 bits.
-*: Rijndael has been nominated as AES due to its
fast key setup, low memory requirements, high level of secur-
ity against attacks and general speed. Here, it is used with a
key length of 192 bits.
-*: Rijndael has been nominated as AES due to its
fast key setup, low memory requirements, high level of secur-
ity against attacks and general speed. Here, it is used with a
key length of 256 bits.
(1!#: Twofish was a final candidate for the AES
(Advanced Encryption Standard). It is rated as just as secure
as Rijndael (AES), but is slower.
=,1!#: Blowfish is a very secure and fast algorithm.
Twofish can be regarded as the successor to Blowfish.
2-*(: CAST is also a very secure algorithm, marginally
slower than Blowfish, but faster than 3DES.
.*: DES is an older encryption algorithm, which is rated as
weak due to its small effective length of 56 bits.
Hash algorithms (Authentication):
%. (default value): MD5 (Message Digest #5) is an older
hash algorithm. It is used with a 96 bit digest length for IPSec.
 -// : All options can be used.
*?-: SHA1 (Secure Hash Algorithm #1) is a hash algorithm
developed by NSA (United States National Security Associ-
ation). It is rated as secure, but is slower than MD5. It is used
with a 96 bit digest length for IPSec.
Note that RipeMD 160 and Tiger 192 are not available for mes-
sage hashing in phase 2.
Use PFS Group As PFS (Perfect Forward Secrecy) requires another Diffie-
Hellman key calculation to create new encryption material, you
must select the exponentiation features. If you enable PFS (
,), the options are the same as for the configuration of
DH Group in the VPN->IPSec->Phase-1 Profiles menu. PFS is
Teldat GmbH
18 VPN
bintec Rxxx2/RTxxx2 351

Table of Contents

Related product manuals