MCC201/MCC201H User manual
4. Remote Configuration • 33
Bitrate control
When there are more than one client connected to the camera, due to bandwidth difference among the clients
some of them do not have enough bandwidth to receive encoded stream completely. In this case, it is possible
to select the way to stream video to clients as following.
- Frame Drop Mode: Encoding is performed strictly according to video settings. When a client is
connected through a network with less bandwidth, it may not receive all the frames. That is, frames are
dropped on sending module if the network is bottlenecked.
- Suppression Mode: Encoding bitrate and frame rate are adjusted not to drop any frames when the
network bandwidths to some clients are limited. In this case, all clients can be affected by the averaged
bitrate and frame rate.
Address Information
Followed network information is displayed (Read only).
IP Address: The IP address for the video server (either defined fixed address or address assigned
by the DHCP).
Domain Name: In case the video server is registered at DDNS server, the registered domain name
is displayed.
MAC Address: Display the MAC address of the video server. In case the video server is registered at
DDNS server, the MAC address is used in DDNS registration.
Connecting: Client IP Addresses that are currently connected to system are listed.
To Next Page
Loading...
