32 • 4. Remote Configuration
MCC201/MCC201H User manual
Related settings are as follows:
-
Destination IP: Set the IP Address of the destination system which will receive MPEG-TS stream.
-
Destination Port: Set the Port of the destination system which will receive MPEG-TS stream.
SNMP
Setup for using SNMP (Simple Network Management Protocol). It is compatible to both SNMPv1 and
SNMPvec. Settings for using SNMP (Simple Network Management Protocol) are as following:
SNMP Listen Port (0, 161, 1025 ~ 65535): The port is for connecting external devices when system
operates as a SNMP client. SNMP is not used by setting 0 value.
SNMP Trap Destination IP: Set the SNMP Trap Destination IP.
SNMP Trap Destination Port (0, 162, 1025 ~ 65535): Set the SNMP Trap Destination Port. SNMP is not
used by setting 0 value.
Multicast
Multicast IP
The Multicast menu is used for configuring the multicast IP address to which media stream is delivered
when a client such as a Decoder, VMS or NVR software is connected in multicast mode. The multicast IP
address selection range is between 224.0.0.0 and 239.255.255.255. The selection can be used only
when media protocol is set to Multicast.
DDNS
Recommended setting is none.
Check IP Disable: If “Check IP Disable” is selected, it will skip to check its own IP. In Fixed IP mode, the
set IP will be registered on DDNS server. In DHCP mode, dynamically assigned IP will be registered on
DDNS server. Normally Check IP Disable should be unchecked in order to obtain public IP in the network.
To Next Page
Loading...
