MCC201/MCC201H User manual
4. Remote Configuration • 31
One-way Streaming
This encoder provides two kinds of one-way (unidirectional) streaming based on UDP to clients: RTP and
MPEG-TS. Both are a kind of broadcasting where traffic from client to server is not generated at all.
RTP (Real-Time Transport Protocol) is an Internet protocol used for transmitting single real-time
multimedia data such as audio and video to a select group of connected clients. Normally RTSP uses
RTP to format packets of multimedia content. RTP menu is used when the RTP only streaming without
RTSP connection. RTP stream will be transmitted to the destination set. The SDP (Session Description
Protocol) file can be found in the server, and a client can retrieve it using http connection.
Related settings are as follows:
- Destination IP: Set the IP Address of the destination system which will receive RTP stream.
If the system is decoder, RTSP authentication information can be entered in the middle of RTSP URL
as follows:
rtsp://admin:1234@192.168.10.100:554/video1
- Destination Port: Set the Port of the destination system which will receive RTP stream.
- User Name: Enter the User name that will be used as session name in the SDP file.
- File Name: Enter the file name that will be used as the name of the SDP file.
Then, it can be accessed through http://ServerAddress/filename
MPEG-TS is a standard format for transmission and storage of audio, video, and data, [7] and is used in
broadcast systems such as DVB and ATSC. Transport Stream is specified in MPEG-2 Part 1, Systems
(formally known as ISO/IEC standard 13818-1 or ITU-T Rec. H.222.0). Transport stream specifies
a container format encapsulating packetized elementary streams, with error correction and stream
synchronization features for maintaining transmission integrity when the signal is degraded.
As MPEG-TS itself supports only AAC as the audio algorithm, only video is streamed when audio
algorithm is set to G.711.
To Next Page
Loading...
