MCC201/MCC201H User manual
4. Remote Configuration • 45
General
Use record
- Off: Recording function will not be used when “Off” is selected.
- Use Disk: Recording will be enabled and data will be written to a disk.
- Use FTP: Recording will be enabled and data will be uploaded to an FTP server.
In this mode FTP upload by event is automatically disabled.
Event Type
Three recording modes are supported: Continuous, Event, Disconnect. In case of Event recording, event
types can be selected among several events. Selected event type is used for configuring the schedule table.
Up to 4 event types can be configured and each event type can be a combination of sensor, video loss and
motion event.
Pre-event Time
Specify the duration of recording before an event happens.
Post-event Time
Specify the duration after the event is cleared.
Schedule Table
Actual recording mode is determined by Schedule Table, where recording mode configured by day
(of a week) and hour.
Each of recording mode configures the recording operation as follows:
- Record off: No recording.
- Continuous: Records continuously.
- Disconnect: Recording is started when the system loses the connection to its last client (Decoder,
VMS/NVR) etc. When there are multiple clients and one of the client is disconnected, this doesn’t happen.
- Event Type: Records when an event configured in Event Type setting happens.
Checking status of recording
Recording status can be checked on the main view page.
Recording status
To Next Page
Loading...
