18 LCD64 - Operation Manual
English
To change his code the manager is required to enter his current manager code
before changing it.
Numbers in brackets (3), (4), (5) and (6) are ON to indicate the number of code digits
left to be entered.
Note: If 6-digit codes are used in the system, then numbers (1), (2), (3), (4), (5) and
(6) are ON. If the new code is repeated correctly the system will conrm it with a
sound signal and will exit automatically from the Manager programming menu.
Changing of Manager Rights
To change his rights the manager is required to enter his current manager code.
Pressing a numeric button alternatively switches over the state of the respective
manager’s right from disabled to enabled. The display indicates the respective op-
erations the manager is allowed to execute. The numbers in brackets indicate the
permitted operations:
LCD Manager rights
(5) Working with Partition A*
(6) Working with Partition B*
* Default settings for Chief Manager in the system. For sub-managers No 1, 2 and 3
there are no programmed rights by default.
NOTE: Disabling all manager rights will automatically erase the programmed code
combination!
Memory LOG review from Manager
To review the memory LOG of events the manager is required to enter his code.
See also the example on page 14.
To enter enable/ disable chime mode, the manager is required to enter his code.
code Manager
Address 2x
new codenew code
4 or 6
digits
repeat
code
Manager
Address 2x
The selected programming is conrmed by
pressing the
button.
code
- previous event,
- following event
To Next Page
Loading...