Teletek electronics LCD64 - Zone Bypassing from Manager; Setting the Clock; Setting the Date; Adding a Proximity Card

LCD64 - Operation Manual 19
English
Pressing a numeric button alternatively switches over the state of the chime from
disabled to enabled. The selected programming is conrmed by pressing the
button. By default the chime is disabled. See also the example for chime enable /
disable from User - page 14.
Zone Bypassing from Manager
To execute a bypass operation the manager is required to enter a valid code:
Pressing a numeric button bypasses the respective zone. The zone number is sur-
rounded by the “(-)” icon. Pressing the same key once again restores the zone by-
pass. The “(-)” icon is removed. Pressing
conrms the selection. See also the
examples for zone bypassing from User - page 14.
Setting the Clock
To set the clock the manager is required to enter his personal code.
Setting the Date
To set the date the manager is required to enter his personal code.
Adding a Proximity card
To use proximity cards the system has to be equipped with a proximity card reader.

Manager Address 2x

Deleting a Proximity card

Manager Address 2x

code

code

code

new time 
code

new date

code
code