NETWORK SETTINGS
On this page you can adjust the network settings of the Plixus engine and configure the camera protocol
which to sent from the Plixus engine to the camera tracking system. Here you are also able to enable the
API.
Figure 1-46 Network settings page
Network Information
You can configure the following network parameters:
Parameter Description
Hostname Is the name of the Plixus engine.
IP address The IP address to access the engine, default value is
192.168.0.100
. When you
change the IP address, you need to restart the engine to complete the action.
Subnet mask Default subnet is 255.255.0.0
Gateway The access point to another network.
Camera Protocol
Camera protocol is disabled by default. When you enable the camera protocol you can configure the
following parameters:
NETWO R K SETTINGS 100
To Next Page
Loading...
