Rear End Connectivity
Figure 1-8 Back view of Plixus AE-R
1. On/off switch
2. Two power connectors for power supply injection
3. Plixus conference ports
4. Two redundant Dante™ network ports
5. Balanced (XLR) and two unbalanced (RCA) audio outputs
6. Balanced (XLR) and two unbalanced (RCA) audio inputs
7. USB 2.0 port to plug in USB device for audio recording
8. LAN port
Power Supply
The Plixus AE-R does not have an internal power supply. By default one external power supply of 220W is
delivered together with the engine. You can use a second power supply for redundancy. However for larger
setups you need the additional power to power the units, preventing you to use the second power supply for
redundancy. See "Power supply design" on page51
Factory Defaults Restore Button
Figure 1-9 Reset button on Plixus AE-R
To restore factory default settings , push the button inside the small hole , next to the headphone connector
for at least 10 sec and release.
PL IX US AE- R 27
To Next Page
Loading...
