Parameter Description
Camera protocol Select the protocol you want to use. Three protocols are available: CAM 1,
CAM 2 and CAM 5. These are the most commonly used camera protocols that
are also provided with CoCon. For more information on camera protocols see
the appendix.
Network protocol Both TCP/IP and UDP are provided.
Port This is the port on the client where the camera protocol is either sent to (UDP)
or where the third party client has to listen to on the Plixus engine (TCP)
IP address When you select UDP you need to specify the IP address of the destination
(third-party).
REST API
The Plixus Core API provides a subset of commands that are available on the CoCon API. The Plixus Core
API has the same communication protocol and command structure as the CoCon API which allows third-
party programmers to simply change the IP address from the CoCon Room Server PC to the Plixus Engine.
By default the API is disabled.
Default TCP port for API connection is port 8890
The following TCP ports are reserved for the Plixus system, do NOT use for camera control: 5011,
5012, 5111, 6011, 6012, 6101, 6111, 6212, 6312 and 8890.
NETWO R K SETTINGS 101
To Next Page
Loading...
