d. Serial number: of the unit
e. Booths: all available booths together with the amount of desk per booth and the units.
How To Initialize Units
There are two initialization modes possible: Open access and Manual initialization.
OPEN ACCESS
This is the default mode. The main purpose of this mode is to provide a quick way to set up
and/or test the system.
Seats are automatically assigned to the units after startup. Assigning seats is done according to
the cabling topology of the units. This means that seat one is assigned to the first unit at port
one of the Plixus engine.
For network extenders connected to the Plixus port, seats will also start with port one of the
network extender. The system automatically discovers the redundant loops.
Interpreter desks are automatically divided into booths according to the setting Number of
desk per booth, under Advanced settings.
Upon restart of the Plixus engine (or Plixus Core) in Open Access, the network will be
rescanned and seats and desks will be assigned accordingly.
In Open Access mode, it is not possible to edit the configuration of the units (seat number or
delegate/chairman priority), nor change the configuration of the booths.
When changing from Open access to Manual Initialization, the initialization and seat order
is preserved.
MANUAL INITIALIZATION
Use Manual initialization when you want to define which unit is assigned to which seat
number. This can be important when using camera tracking as well as CoCon seat allocation.
Manual initialization allows you to edit the configuration in terms of chairman / delegate priority
and booth configuration after initial configuration.
Click Open initialization to start the initialization phase. This causes uninitialized
microphones to blink red and initialized microphones to blink green. Add units to the
initialization list by pressing the microphone button. During manual initialization you can
perform the following actions on the units:
INITIALIZATIO N 83
To Next Page
Loading...
