AUDIO SETTINGS
On the Audio page you can configure all general audio settings for the Plixus system.
General Volume
This sets the volume for the loudspeakers in the room. The value can range from -96dB to +6dB. You can
also change the volume by turning the control dial of the MME or volume dial of the AE-R.
Dynamics Processing
The dynamics processor settings are global settings that are applied to every microphone unit individually.
These settings determine the dynamic range of the audio input.
There are four default presets available for the user, for a detailed description of these presets see the table
below. Click Advanced settings to see these presets and edit them. However, you cannot overwrite
predefined options, you can only save changes as Custom preset 1 or 2.
Preset Description
Default This preset has been optimized for medium-size conference rooms.
Default (without noise gate) Removes the noise gate, use when the noise in the room is limited.
External speakers Shifts the knee-point of the compressor stage to a higher input value resulting
in less chance of feedback when external speakers are used.
AUDIO SETTINGS 91
To Next Page
Loading...
