: click to swap unit. When a unit is faulty, it will be greyed out in the web server.
Click the icon and enter the serial number of the new unit. Click the checkmark icon
to confirm. Note that you can only replace units with units of the same type.
: click to modify the unit number. If you do this during the initialization, the next
assigned unit number will be the highest unit number + 1.
: click to remove individual units during initialization. After removal the
microphone LED will blink red again.
It might take several seconds before the microphones start to blink when you click Open
initialization.
You can only manual initialize units with a microphone button. Units without this button (e.g.
Confidea channel selector) are automatically assigned to a seat.
Click Stop initialization to finish and the seats are automatically assigned to the units.
Stopping initialization might take a while, up to one moment depending on the number of
units. The seat number will automatically map to the unit number and the Lingua ID’s to desks
in booths according to the setting Desk per booth.
Click Edit configuration to change the following settings
Chairman priority: click the start icon ( or ) to change priority of the unit. A
unit that is hardware-wise not a chairman unit can receive chairman properties. This
then becomes a VIP unit.
Booth configuration: click the booth icon to change the booth configuration.
Create new booths or group desks by changing booth and desk number.
Do not reload the page when editing the configuration.
Do not change properties during meetings, because this can disturb your meeting.
You can also use CoCon to configure different settings such as the priority of the unit.
Click Clear initialization to clear the initialization list, as consequence all units will start to
blink red. It is only possible to clear initialization when the initialization is open and units are not
faulty. Confirm to finish clearing the initialization.
INITIALIZATIO N 84
To Next Page
Loading...
