Telex AIRMAN 8+ - Page 39

AIRMAN 8+ Assembly | en 39
Bosch Security Systems, LLC
Customer Maintenance Manual
2024-11 | 07 | F.01U.387.060
i
Notice!
Take care to verify the orientation of the yoke, because it does not rotate 360°.
6. Place the cover on the housing.
1. Using a T-5 screwdriver, replace the three screws (as shown) to attach the yoke and
housing to the PCBA.
Models -0210, -0211, -0212 Model -0214
2. Position the overhead cord in the retaining clip and align the knob of the faceplate
toward the bottom.
3. Align the four tabs on the faceplate, and then rotate counterclockwise to lock.
i
Notice!
Verify all four tabs engage and retaining tabs are in the groove.
4. Carefully wind the overhead cord around the glider.