TP-8/16/24/32/64S User Manual Version No.: V1.2
- 63 -
Root command level: Cursor display with “＃” after, it means the current command is in the root
command layer;
Sub-command level: current setting directory name with “>” and cursor display after , it means the
current command is in the sub-command layer;
6.1.3 Command Classification and Command Format
Two major commands are root command and sub-command:
Root command
It refers to the first-layer command set after entering CLI, including
codec: compressed chip configuration command
network: network parameters setting command
protocol: protocol-related parameters setting command
switch: CLI command entering data configuration
system: command of system-related parameters setting and tool
manage: CLI command of management protocol-related settings
logout: CLI cancellation command
Help: command for help
show: various parameters display command
reboot: MDU restart command
take-effect: command to take make parameters effect.
Among the above said commands, 1～5 belong to the directory commands, namely, they have
sub-commands.
Sub-command
It refers to the command set after entering a particular setting directory, see below:
audio_port，cid，cn，dtmf，df_codec，ec，fax，fax_ctrl_mode，
g.723.1，gain，jb，line_hook，oa，pktintvl，priority，rfc2833_pt，
rfc2833_neg_mode，rfc2833_red_pt，ring，ring_pattern，sc，
t38_ev_det_mode，t38_mode ，t38_port，tone，tone_duration，
dm_timer，keepRTP，vbd，show，exit，help
sub-command
dns，gateway，hostname，ip-mask，mode，ntp，vlan，pppoe，
show，exit，help
sub-command
al_par_en ， cmddelay ， digitmap ， empty_no_with_blank ，
ep_name，ephterm，heartbeat，howler_logout，local_ctrl_resp，
local_tone_ctrl，md5，mg，mgc，mgc2，mgc3，mgcmode，port_vis，
pos_num，reg_reason_code，remote_dscr_resp，rereg，
resend_time ， send_local_sdp ， sig_ab_mode ， trans_type ，
wt_to_handle，show，exit，help
debug，dmesg，download，ifshow，load，logoutep，logoutmg，
mem，regmg，resourceinquiry，ping，protocol，ps，regep，
To Next Page