Telstra 13350 - Page 75

75
Both your and your caller’s telephone service providers must use caller ID
compatible equipment.
If you subscribe to high-speed Internet service (DSL - digital subscriber
line) through your telephone line, you must install a DSL lter between the
telephone line cord and the telephone wall jack. The lter prevents noise
and Calling Number Display problems resulting from DSL interference.
Contact your DSL service provider for more information about DSL lters.
My telephone does not receive Calling Number Display when on a call.
Make sure you subscribe to Calling Number Display with call waiting
features from your telephone service provider. Calling Number Display
feature works only if both you and the caller are in areas offering Calling
Number Display service, and if both telephone service providers use
compatible equipment.
The messages on the answering machine are incomplete.
If a caller leaves a very long message, part of it may be lost when the
answering machine disconnects the call after the preset recording time.
If the caller pauses for too long, the answering machine stops recording
and disconnects the call.
If memory on the answering machine becomes full during a message, the
answering machine stops recording and disconnects the call.
If the caller’s voice is very soft, the answering machine may stop recording
and disconnect the call.
The messages are very difcult to hear.
Press
p
/VOL on the telephone base, or VOL
+
on the cordless handset, or
VOL
+
on the pendant to increase the listening volume.
The answering machine does not answer after the correct number of rings.
Make sure that the answering machine is on. ANS ON should show on the
cordless handset and ANS light on the telephone base should be on.
•
•
•
•
•
•
•
•
•