Teltonika FM3602 - Setdigout ## Y1 Y2; Getparam; Setparam; Getparam 1271 X;212 X

63
6.1.11 setdigout ## Y1 Y2
Sets digital outputs to ON or OFF state (for some time if needed). Value is written as a row
for OUT1 and OUT2 values.
Example: ‘setdigout 01 0 5’ will set OUT2 to high level for 5 seconds, while OUT1 to low
level.
To ignore one digital output value and make ON/OFF state only to another digital output in place
of 0 or 1 values, “?” must be used.
Example: ‘setdigout ?1’ will set OUT2 to high level for indefinite period of time while
OUT1 remains as it was set before.
6.1.12 getparam ####
Read parameter value. ID consists of 3 or 4 digits. Detailed list of parameters and IDs can
be found in chapter number 8 “Parameter List”
Example: ‘getparam 1245’ command will request server IP address.
6.1.13 setparam ####
Sets new value for parameter. ID consists of 3 or 4 digits. Detailed list of parameters and
IDs can be found in chapter number 8 “Parameter List”
Example: ‘setparam 1245 127.0.0.1’ will change configured IP address.
6.1.13. getparam 1271 X/212 X
X values can be 1,2,3.
If X = 1, Operator codes from 0-19 are read from configuration and sent via SMS.
If X = 2, Operator codes from 20-39 are read from configuration and sent via SMS.
If X = 3, Operator codes from 40-49 are read from configuration and sent via SMS.
If X = any other, Operator codes from 0-19 are read from configuration and sent via SMS.
6.1.14. setparam 1271 X/212 X
If X is from 0 to 49, X means index of operator code which has to be configured. Up to 20
operator codes may be configured in 1 SMS. Example: Setparam 1271 16 24602,24603,24605
,here 16
th
, 17
th
and 18
th
operator codes are set. Note! Other operator codes are left unchanged
in the configuration.
6.1.15 readops #
Send from device Operator List.
1 – send first 20 operator codes, 2 – send from 21
st
to 40
th
operator codes, 3 – send all
other operator codes.
6.1.16 flush #,#,#,#,#,#,#
Initiates all data sending by GPRS to specified target server. Comma separated parameters
go as numbered:
1.# - IMEI
2.# - APN
3.# - GPRS LOGIN
4.# - GPRS PASSWORD
5.# - IP
6.# - PORT