Teltonika FM3602 - Can200;All-Can300 Program Number Selection; CAN200;ALL-CAN300 Program Number Configuration Via SMS Command; Selecting LV-CAN200;ALL-CAN300 Program Number Manually

91
LV-CAN200/ALL-CAN300 Technical characteristics:
PARAMETER
VALUE
Supply voltage
9 to 50V
Power supply current
Average 10mA
Max (peak) 100mA
Working temperature
-40..85 °C
Max working humidity
60 % (non condensate)
9.2 LV-CAN200/ALL-CAN300 program number selection
LV-CAN200/ALL-CAN300 must be set to program number which depends on vehicle
model.
Correct program number is always written on LV-CAN200/ALL-CAN300 mounting scheme.
Please contact Your Teltonika sales manager to get latest supported vehicle list and
mounting scheme for your vehicle, please provide CAR manufacturer, model and year
information.
9.2.1 LV-CAN200/ALL-CAN300 program number configuration via SMS command
LV-CAN200/ALL-CAN300 program number can be set remotely, using SMS command:
lvcansetprog X
X is new program number value.
9.2.2 Selecting LV-CAN200/ALL-CAN300 program number manually
Steps to set program number:
• Hold SWITCH down till LED stars blinking
• Release the SWITCH
• Then LED starts blinking and counting first digit of program number, (one blink
means digit 1, two blink digit 2 etc.)
• To stop counter push SWITCH
• Release the SWITCH, then LED starts blinking and counting second digit of program
number
• To stop counter push SWITCH
• Release the SWITCH, then LED starts blinking and counting third digit on program
number
• To stop counter push SWITCH
• Release SWITCH, if programming is succeded LED will blink 10 times