PHONE SETUP
26 28xx CIP-D User Guide
6. Press and hold the Speaker button while you
plug the Ethernet cable back into the Internet
port and continue pressing while the phone
boots up.
The phone will boot up in “Safe Mode”,
allowing you to upgrade the phone.
7. Enter the IP address from step 4.
8. Enter the IP address of the TFTP Server where
the rom files are located.
9. In the Protocol field select the desired
application (SIP or CIP-D).
NOTE: Use the down Navigation Keys to move
through fields. Use the right Navigation Key to
select the Protocol.
10. Press the OK button on the Navigation Keys.
The phone will reboot, and on your PC you
should see the phone connecting and
downloading the rom file.
11. When the phone comes back up, verify that
the correct firmware version has been loaded
by pressing the Menu soft key and then the
DTMF digit 2.
12. Disconnect the Ethernet Cable from the
phone.
To Next Page
Loading...
Need help?
General
