TEM Opera Plus Series - Page 30

TEM A07EXXXX – 1 Unit Transmitters Page 30
When cursor is on “OFF” indication, selecting the UP switch the “OFF” is disabled and now “ON” Is enabled. Note
that when “ON” is enabled is possible to move with Right and Left switches the cursor so will be possible to select
the Reduction power level, in the example is 125W
0 4 P o w e r R e d u c t i o n
S t a t u s =
▄
▄O N
▄1
▄2
▄5
W
S t a r t = 1 2 : 0 0
S t o p = 1 3 : 0 5
By Down switch the flashing cursor will be move to the Second “ Start” Line, and with the Right and Left switches
the cursor can be placed on the Numbers so will be possible to program the Start Time of reducing Power, in the
example 23:00 (11:00 pm)
0 4 P o w e r R e d u c t i o n
S t a t u s = O F F
S t a r t =
▄
▄2 ▄3 : 0 0
S t o p = 1 3 : 0 5
By Down switch once again the flashing cursor will be move to the Third “ Stop” Line, and with the Right and Left
switches the cursor can be placed on the Numbers so will be possible to program the Stop Time of reducing
Power, in the example 05:30 (11:00 pm)
0 4 P o w e r R e d u c t i o n
S t a t u s = O F F
S t a r t = 2 3 : 0 0
S t o p =
▄
▄0
▄5
: 3 0
When all the settings are done, press the “OK” switch and no more flashing cursor must be visible. Power
reduction is active.