Tenda N3L-4H - Page 113

Document Version: V1.3
105
Parameter
Description
Clear
Used to clear the time that has been set in the timetable below.
Click this button to clear the recording time in the timetable below.
All Normal Recording
Used to set a 24-hour normal recording from Monday to Sunday with
one click.
All Alarm Recording
Used to set a 24-hour alarm recording from Monday to Sunday with
one click.
Edit
Used to edit the schedule for a specific time in detail.
Clear Schedule
Used to clear the current recording schedule.
Sync to
Used to synchronize the current schedule with other channels.
Post-record
Only applicable for Alarm. Click Advance to enter the page.
Specifies the time of continuous recording after an alarm is finished.
Configure Schedule
Assume that you want to set a schedule for D1, D2, D3, and D4 cameras as shown in the table
below:
Recording
Recording Time
Recording Type
Monday to Sunday
00:00 to 8:00
Not recording
Monday to Sunday
8:00 to 12:00
Alarm recording
Monday to Sunday
12:00 to 14:00
Normal recording
Monday to Sunday
14:00 to 18:00
Alarm recording
Monday to Sunday
18:00 to 24:00
Normal recording
After an alarm recording plan is set for the corresponding channel, the alarm event also
needs to be set for the channel in the Alarm Management.