It is available only when Exception Type is set to Channel error.
Specifies the channel chosen to set the Channel error alarm.
Specifies the alarm mode of the NVR after an alarm is triggered. The alarm mode
of each Exception Type is set independently, and the supported alarm modes
are different. The actual page prevails.
- Pop-up Window: After an alarm is triggered, an alarm notification will be
displayed in a pop-up window on the Live View page.
- Send Email: After an alarm is triggered, the system will send an alarm email
to the preset Recipient email. You need to set the relevant parameters of
email for this alarm method to take effect. Refer to Email Configuration for
details.
- Message Notification: After an alarm is triggered, the system will send an
alarm notification to TDSEE App. The NVR needs to be added successfully
through TDSEE App. Refer to Manage the NVR through TDSEE App for
details.
Configure Exception Detection Alarm
Scenario: Assume that you have set up a monitoring network with the NVR, and the camera D1 is
installed at the door.
Requirement: When the system detects the channel is abnormal and the LAN port connection is
abnormal of the NVR, it will alarm through a pop-up window. When the system detects
unauthorized access, it will push an alarm notification to TDSEE App.
Solutions: The Exception Detection function can meet this requirement.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > Alarm > Exception Detection.
To Next Page
Loading...