OPERATION
PLACING A LOAD
TH644C, TH842C, TH844C
When placing a load with the Model TH644C,
TH842C, or the TH844C the rear axle stabilizing
cylinders need to be taken into consideration. When
the boom reaches
an
angle
of
60 DEGREES, all
frame leveling and transmission functions are disabled
and the rear axle stabilizing cylinders become locked.
This
DOES NOT affect any boom or fork
functions.
To
unlock the rear axle stabilizing cylinders
and enable the transmission functions, lower the
boom
to
a position less than 60 degrees.
4-19
To Next Page
Loading...
