4-5
Operating the Truck
641
6
6. Fuel Level Gauge
Check fuel level. Tank should be filled at end of each shift to prevent
condensation.
7. Body and Disc Brake Cooling Hydraulic Tank - Cold Oil Level
With the body fully lowered, the oil should be showing between the upper and
lower lines on the sight gauge (on tanks with two sight gauges, the bottom
gauge should show full). Add fluid, if low.
8. Steering and Braking Hydraulic Tank - Cold Oil Level
With the engine off, turn the steering left and right to discharge the steering
accumulator. Operate the service brake continuously to discharge the brake
accumulators. Oil should be showing between the upper and lower lines on
the top sight gauge (on tanks with three sight gauges, oil should be showing
in the middle gauge). Add fluid, if low.
9. Transmission - Cold Oil Level
This check is made only to determine if the transmission contains sufficient
oil for safe starting. Make sure there is some oil showing on the sight gauge
before starting the engine. Add oil if low.
10. Seat and Seat Belts
Adjust the seat position and lap belt as required to allow complete machine
control at all times with minimum fatigue. Make sure the seat belt does not
restrict movement for proper machine operation.
7
8
2105
2105
10
9
472
263
To Next Page
Loading...
Need help?
General
