EasyManua.ls Logo

Terex TR100 - Safe Operating Practices

Terex TR100
138 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-8
Safety
Pre-Starting
* If engine is to be started and run indoors, ensure proper ventilation to
remove deadly exhaust gases.
* Always perform 'Pre-Starting Inspection' instructions described on
page 4-3 to ensure the vehicle is ready for operation.
* Always walk around the vehicle to make sure no-one is working on,
underneath or close to the vehicle before starting the engine or
operating the vehicle.
* Adjust, secure and latch the seat and fasten the seat belt before
starting the vehicle.
* Sound horn before starting the engine or beginning to move the
vehicle; two blasts for forward and three blasts for reverse.
Starting
* Do not start the engine or operate any control if there is a 'DO NOT
OPERATE' or similar warning sign attached to any control.
* Use jumper cables only as recommended. Improper use can result in
battery explosion or unexpected vehicle motion.
* Always obey 'Starting the Engine' instructions described on page 4-8.
* Do not bypass the vehicle’s neutral-start system. The neutral start sytem
must be repaired if it malfunctions.
* Start and operate the vehicle only from the operator’s seat.
Operating
* Ensure all cab glass, mirrors and light lenses are clean during vehicle
operation for maximum visibility. Ensure mirrors are properly
set / positioned.
* Always keep cab floor clear of anything that could restrict full operation of
pedals.
* Always make sure all gauges, warning/indicator lights and controls are
working properly before operating the vehicle.
* Always perform 'Pre-Operating Checks' described on page 4-11 to
ensure the vehicle is ready for operating.
* Always wear seat belts when operating the vehicle.
* In the event of a loss of steering pump output pressure, a fully
pressurized accumulator provides a maximum of two lock to lock turns of
the front wheels. A red warning light on the instrument panel illuminates
when steering pressure falls below 83 bar (1 200 lbf/in²). If this light
illuminates, indicating a loss of steering power, the machine must be
stopped immediately and no further operation attempted until the fault
is corrected.
* Do not operate if exposed personnel enter the immediate work area.
1773
1861
DO NOT
OPERATE
1775
1862

Table of Contents

Other manuals for Terex TR100

Related product manuals