Page IV
⇒ Do not bend, twist or apply excessive pressure to the power cable.
The internal wires may become uncovered or be damaged.
⇒ Do not modify the power cable.
⇒ Do not pull the cable to disconnect it.
⇒ Do not place heavy objects on the power cable.
⇒ Keep the power cable away from sources of heat.
⇒ Be careful not to get caught up in the power cable.
⇒ Clean the connectors regularly. If the connectors are covered in
dust or exposed to humidity, the insulation can deteriorate and
cause the recorder to malfunction.
Do not place the recorder near sources of heat, in excessively dusty
environments or where it will be subject to mechanical shocks.
Handle the power cable and connectors as indicated below so as to
prevent electrical shock or damage:
Carefully read all the instructions in this manual before connecting,
using or configuring this product.
TESMEC S.p.A. reserves the right to make technical and constructive
changes to the DLR300 without prior notice and if deemed necessary
To Next Page
Loading...
