Page V
1. GENERAL INDEX
Page
1. GENERAL INDEX V
2. GENERAL INFORMATION AND REQUIREMENTS 1
2.1 MANUFACTURER 1
2.2 TYPE AND FIELD OF USE 1
2.3 PARTS GUIDE 2
2.3.1 UPPER PANEL 2
2.3.2 REAR PANEL 3
2.3.3 STANDARD ACCESSORIES 3
2.4 INTERNAL MEMORY 4
2.5 POWER SUPPLY 4
2.6 APPLIED REGULATION 4
3. USING THE RECORDER 5
3.1 POSITIONING AND CONNECTING TO THE MACHINE 5
3.2 SWITCH-ON 5
3.3 ACCESS TO THE MAIN MENU 6
3.4 SETTING THE WORK PARAMETERS 6
3.4.1 SETTING THE ROPE DIAMETER 6
3.4.2 SETTING THE SAMPLING 7
3.4.3 SETTING THE LIMIT VALUE 7
3.4.4 SETTING THE TYPE OF PRINT 7
3.4.5 SETTING THE UNITS OF MEASUREMENT 7
3.4.6 SETTING THE LANGUAGE 8
3.5 SETTING THE CLOCK 8
3.5.1 SETTING THE DAY 8
3.5.2 SETTING THE DATE 8
3.5.3 SETTING THE MONTH 8
3.5.4 SETTING THE YEAR 9
3.5.5 SETTING THE HOURS 9
3.5.6 SETTING THE MINUTES 9
3.5.7 SETTING THE SECONDS 9
3.6 SETTING THE DISPLAY CONTRAST 9
3.7 BEGINNING AND END OF THE MONITORING PROCESS 10
3.8 FULL MEMORY 12
3.9 MANAGING SAVED AND PRINTED CABLE LAYING OPERATIONS 12
3.9.1 DISPLAY CABLE LAYING OPERATIONS 13
3.9.2 PRINT CABLE LAYING OPERATIONS 13
3.9.3 SAVING AN INDIVIDUAL CABLE LAYING PROCESS 14
3.9.4 SAVING ALL THE CABLE LAYING OPERATIONS 15
3.9.5 DELETING AN INDIVIDUAL CABLE LAYING PROCESS 16
3.9.6 DELETING ALL THE CABLE LAYING OPERATIONS 16
3.10 REPLACING THE PAPER ROLL. 17
ATTENTION! 18
4. SETTING CONSTANTS AND CALIBRATIONS 19
4.1 STEPS TO SET CONSTANTS AND CALIBRATIONS 19
4.1.1 SETTING THE COMPANY NAME 19
4.1.2 SETTING THE DIGITAL PARAMETERS 19
4.1.3 SETTING THE ANALOGUE PARAMETERS 21
4.1.4 SETTING THE FUNCTIONAL PARAMETERS 23
4.1.5 SETTING THE CALIBRATIONS 24
4.1.6 SETTING THE SERIAL NUMBER 27
4.1.7 SETTING THE COUNTER 27
4.2 CONFIGURATION MANAGEMENT PROCEDURE 28
4.2.1 RESTORE FROM A PEN DRIVE 28
4.2.2 WRITE TO A PEN DRIVE 28
4.2.3 PRINT CONFIGURATION 29
4.2.4 LOADING A NEW LANGUAGE 31
4.2.5 RESTORING THE DEFAULT CONFIGURATION 31
5. MANAGING ERRORS 32
5.1 ERROR 1 – CHECK GENERAL PARAMETERS 32
5.2 ERROR 2 – EPROM ERROR 32
To Next Page
Loading...
