Revision Release date Improvements
sometimes still had alarm settings stored after a
hardware reset, has been rectified
• The error that the set user language
was not taken into account in the setting of the
communication rate, has been rectified
• The error that the change of the user
role was not always taken over, has been
rectified
• The error that during registration the
previously selected country can no longer be
changed after selecting the language, has been
rectified
• The error that the e-mail address for a
deleted user can no longer be used, has been
rectified
• The error that licence information was
sometimes displayed incorrectly in the Quick
Start Guide, has been rectified
• The error that for the dew point and
absolute humidity channels the alarm did not
function, has been rectified
• The error that when measuring in °F
the e-mail and SMS alarms were always shown
in °C, has been rectified
• The error that the measurement
locations could not removed from existing alarm
settings, has been rectified
• The category "User groups" has been
removed
• The colour design on the web
presentation is now uniform
• With immediate effect, the dash board
displays only active alarms
• Browser compatibility problems in the
presentation of the dashboard have been
corrected
• In a CSV report, tables and alarms
cannot be integrated simultaneously, although
this combination was selectable in the software
interface. This error has been rectified
• Decimal points and commas are
supported for alarm limit value input
• Limit values can be entered in °F or
To Next Page
Loading...
