CBLé System Guidebook 19
Chapter 3: Using the CBL System
This chapter describes how the CBL is set up and controlled by commands
sent from a connected calculator. Parameter descriptions are provided for each
of the commands.
Chapter Contents
What a Typical Program Might Include
.........................
20
About Automatic Probe Identification (
AutoIDENT
)
............
21
Understanding Modes
.........................................
22
Understanding CBL Commands
................................
24
About CMD0—All Clear
.......................................
27
About CMD1—Channel Setup
.................................
28
About CMD2—Data Type and Display Setup
....................
36
About CMD3—Sample and Trigger Setup
.......................
39
About CMD4—Conversion Equation Setup
.....................
47
About CMD5—Data Range Setup
..............................
49
About CMD6—Multimeter Mode Setup
.........................
52
About CMD7—Request Status
.................................
54
To Next Page
Loading...
Need help?
General
