52 CBLé System Guidebook
About CMD6—Multimeter Mode Setup
CMD6 Operations
CMD6
sets up the CBL to use
CH1
or the
SONIC
channel as a multimeter.
Multimeter mode only works on one of these two channels at a time. The
first element in the list must be a 6 to designate
CMD6
.
List Syntax
{6,set_reset,operation}
Note: Pressing M lets you use the CBL in Multimeter mode as a
stand-alone device without requiring setup commands from the
calculator.
Set/Reset
This parameter lets you set or reset the Multimeter mode. (Default:
1
)
0
1
Restore to Communications mode
Set to Multimeter mode
When the CBL is in the Multimeter mode:
¦
CMD6
is the only supported command.
¦ Active channel defaults to
CH1
.
¦ Sample time defaults to 0.5 seconds.
¦ Trigger defaults to 1 Volt on the rising (+ +) edge with the
corresponding default trigger threshold for period and frequency.
¦ Result of the sample is displayed, but is not available for retrieval by
a calculator. This prevents overwriting collected data from
Communications mode.
Operation
This parameter selects the multimeter operation to measure. (Default:
1
)
1
AutoIDENT
Note: If
AutoIDENT
is not active, the operation defaults to
Voltage, 0 to 5 Volts
2
3*
4
5
6
7**
8**
Voltage measurement
Current measurement
Resistance measurement
Period
Frequency
Meters
Feet
(„10 Volts)
(„10 Amps)
(1 Kohms to 100 Kohms)
(0.000004 sec to 50 sec)
(0.02 Hz to 250 KHz)
* Based on voltage conversion on Vin of 1V = 1A.
**Meters or feet apply only to the ultrasonic channel.
To Next Page
Loading...
Need help?
General
