Texas Instruments CBL

CBLé System Guidebook 53
Multimeter Mode Setup Instruction Examples
This example collects one data sample on
CH1
. Voltage is measured and
displayed on the CBL.
{6,1,2}
6= Multimeter Mode Setup command.
1= Set to Multimeter mode.
2= Measure voltage (±10 Volts) from
CH1
.
This example sets up the CBL according to the
AutoIDENT
resistance
sensed. With the TI temperature probe connected to
CH1
, resistance is
measured and converted to temperature in ºC.
{6,1,1}
6= Multimeter Mode Setup command.
1= Set to Multimeter mode.
1=
AutoIDENT
.