30 CBLé System Guidebook
About CMD1—Channel Setup
(Continued)
CH1, CH2, CH3: Analog (continued)
The Statistics option creates four lists: mean, standard deviation,
minimum, and maximum. The original data is not displayed and is
discarded after the statistical summary is computed. (Refer to the
example on page 34.) This option is valid only for lists and matrices. This
option is not valid if period or frequency is selected and will produce an
E.13 error message (page 56).
Note: Post-processing will not operate if the Number of Samples
parameter in Sample and Trigger Setup (
CMD3
) is L1 (for real-time
display of collected data). Additionally, only one channel can be active
when Statistics post-processing is selected, or it will produce an E.07
error message (page 56).
Statistics Samples
This parameter lets you select the number of statistics samples to collect
for each computed statistic point. It applies only when Post-processing is
set to 3 (Statistics is selected). (Default:
10
)
2–512 (
10
) Number of samples
Conversion Equation
This parameter lets you select whether the Conversion Equation is on or
off for the selected channel. 0 (zero) turns it off, and 1 turns it on.
(Default:
0
)
Conversion Equation is a CBL feature that converts a measured physical
unit such as volts or ohms into a more useful measurement unit such as
Newtons or degrees Celsius. The equation types are defined in
CMD4
(Conversion Equation Setup) on page 47.
To Next Page
Loading...
Need help?
General
